Before and After in Lidar: Three Places Around Houston
Where the ground dropped and where it rose between two USGS lidar surveys of the same ground, measured by subtracting one from the other. Three places, two in Montgomery County and one in Pasadena, each one link away on the map.
USGS publishes a 3.3 ft lidar DEM from many of the lidar surveys it holds, all on the same grid, so two surveys of the same ground line up cell for cell. Subtract the older one from the newer one and what is left is change. In Texas, USGS publishes lidar DEMs from two surveys of the same ground in parts of Houston, Galveston and Tyler. Many places have only one such survey so far.
All three places compare TX_CoastalRegion_2018_A18, collected January to June 2018, with TX_Houston_B24. USGS lists the later survey as collected February to March 2024 over the two Montgomery County places and February 2024 to January 2025 over Pasadena, because the survey was flown in parts. The site takes each survey’s years from its collection dates, not its name.
On the change map, red is ground that went down and blue is ground that came up, and differences under ±1 ft are left clear as survey noise. The figures below are for a box around each place, its size given with each one, computed with the same code the map runs. What each place looks like is described from the latest USGS aerial photo of the box; on the map, the panel’s Before & after photos swipes between the years of aerial photos TxGIO holds there.
Near Lake Spendora: woods and fields graded into a new neighborhood
Southeast Montgomery County, near Lake Spendora · box about 0.83 mi across, 440 acres compared · surveys TX_CoastalRegion_2018_A18 (January to June 2018) and TX_Houston_B24 (February to March 2024)
In the latest USGS aerial photo most of this box is bare, freshly graded ground, laid out in new streets and lots, with streets and lots already built along its north-east side and strips of woods left standing between the graded blocks.
The change map shows the whole development. Broad sheets of light blue cover the graded ground: across the box 786,756 cu yd was raised over 151 acres, the largest raised area of the three places, spread thin rather than piled high. Among them sit a few solid red blocks and a long red strip following the curving edge of the development, ground cut down by as much as 28 ft; in all 617,427 cu yd was lowered over 78 acres.
Lowered and raised volumes come out close to each other, which is what grading on a flat site tends to look like: ground dug out in one place goes back down nearby. The highest rise is only 14 ft. The woods left standing, and the buildings beyond the development’s north-east edge, read clear.
- Ground lowered: 617,427 cu yd over 78 acres, the deepest by 28 ft
- Ground raised: 786,756 cu yd over 151 acres, the highest by 14 ft
- Median change across the box: 0.1 ft
On the map, choose Compare this view, then Compare surveys. Before & after photos then swipes between two years of aerial photos.
Near Roman Forest: a pit dug into the woods
Southeast Montgomery County, near Roman Forest and Woodbranch · box about 0.83 mi across, 440 acres compared · surveys TX_CoastalRegion_2018_A18 (January to June 2018) and TX_Houston_B24 (February to March 2024)
In the latest USGS aerial photo a pale, bare excavation sits in the west half of the box, cut into pine woods, with haul roads leading off to the west and north. The rest of the box is woods and wooded home sites along small streets.
On the change map the excavation is one solid red block: 790,375 cu yd of ground gone from 48 acres, the most ground lost in any of the three boxes, the deepest by 22 ft. Thin red lines follow the haul roads. Almost nothing came up: 19,746 cu yd raised over 5.8 acres.
Unlike the neighborhood above, nothing here balances: the ground removed left the box. In a working pit, where faces are cut back and water can stand on the floor on the day of a flight, single extremes are the least reliable figures; trust the broad patch. The woods and streets around it read clear.
- Ground lowered: 790,375 cu yd over 48 acres, the deepest by 22 ft
- Ground raised: 19,746 cu yd over 5.8 acres, the highest by 7 ft
- Median change across the box: -0.1 ft
On the map, choose Compare this view, then Compare surveys. Before & after photos then swipes between two years of aerial photos.
In Pasadena: a mound raised inside an enclosed site
City of Pasadena, Harris County · box about 0.83 mi across, 440 acres compared · surveys TX_CoastalRegion_2018_A18 (January to June 2018) and TX_Houston_B24 (February 2024 to January 2025)
In the latest USGS aerial photo a large mound, ringed by a perimeter road and an embankment, fills an enclosed site in the middle of the box, with large warehouses to its west, neighborhoods to its south and open green ground with ponds to its east.
The change map lights up only inside that site. Its northern and central part is deep blue: 1,133,944 cu yd raised over 38 acres, the most ground gained in any of the three boxes, the highest by 77 ft. Red patches along its edges, 296,968 cu yd lowered over 22 acres and the deepest by 37 ft, are ground cut down around the mound.
Outside the site the warehouses, streets and houses read almost entirely clear: the ground there did not move between the two surveys.
- Ground lowered: 296,968 cu yd over 22 acres, the deepest by 37 ft
- Ground raised: 1,133,944 cu yd over 38 acres, the highest by 77 ft
- Median change across the box: -0.1 ft
On the map, choose Compare this view, then Compare surveys. Before & after photos then swipes between two years of aerial photos.
Compare two surveys anywhere they overlap
Frame an area up to 1.24 mi across, or select a parcel, and compare. Free to use, no account.
Open Elevation Change →How to read a change map
- Built-up ground, such as a pad, a fill or a road embankment, shows as a patch of blue; ground cut down shows as red.
- A graded development shows wide, pale blue sheets where lots were raised a little, with red where ground was dug out nearby.
- A working pit shows red where material was dug out, and often blue close by where the floor was built back up or material was piled.
- A whole area one color can be real, or an offset between the two surveys. The panel says by how much, and names the geoid models when the surveys used different ones, as the pair here does (GEOID12B and GEOID18).
- A lake, bayou or flooded pit one flat color is the water standing at a different level on the two survey days, not the ground.
- Speckle under dense trees, on water and on steep faces is mostly noise. Trust broad, consistent patches.
Take it further
The change downloads as a GeoTIFF for GIS with a pass. The photos are on the map only.
Related guides
- Lidar coverage in Texas — which lidar project covers an address, and when it was flown.
- Lidar data for Texas — USGS 3DEP and where Texas’s lidar comes from.
- Terrain checks before buying rural land — the checks to run on acreage before an offer.
Frequently asked questions
Can I do this for my own property?
Where USGS publishes a 3.3 ft lidar DEM from two surveys of the same ground, yes. In Texas, USGS publishes lidar DEMs from two surveys of the same ground in parts of Houston, Galveston and Tyler. Many places have only one such survey so far. Open Elevation Change, frame an area up to 1.24 mi across or select a parcel, and the panel lists the surveys that cover it. Data Here shows which surveys cover a spot.
How much can I trust the numbers?
Changes smaller than ±1 ft are treated as survey noise and left out. In all three boxes here the median change was 0.1 ft or less, so the two surveys agree closely on ground that did not move, even though they were processed with different geoid models. The volumes are good for scale and comparison: indicative only, not a survey.
Why does a new building or bridge not show?
The comparison uses bare-earth lidar, which has buildings, bridges and trees removed. New buildings and cleared trees mostly don’t show; the earthworks under and around them do.
Why are there no lakes, bayous or flooded pits here?
Lidar models show lakes, bayous and ponds as a flat water surface. Where the water stood at a different level on the two survey days, the whole surface reads as one color, which is a change in the water, not the ground. The places here were chosen away from open water and from pits holding water.
Will I get exactly these figures?
Only for exactly these boxes. The links open the map on each spot; the area you frame or draw there will differ a little, and so will the totals.
Can I download the change?
Comparing on the map and the before-and-after photos are free. The change itself downloads as a GeoTIFF, which needs a pass. The photos are for viewing on the map only.
About the data
Ground elevations come from the USGS 3D Elevation Program (3DEP) seamless bare-earth model, with elevations above NAVD 88. Source cells are 3.3 ft per pixel in the finest work units, with about 9.8 ft per pixel and 33 ft per pixel sources elsewhere. USGS elevation data is public domain. Lidar coverage and source dates vary across Texas. Check your site against the USGS 3DEP work-unit index; an unavailable lookup means coverage is unknown. The comparisons read each survey’s own USGS 3.3 ft lidar DEM straight from the USGS files, not the seamless model the other tools use. More from the USGS 3D Elevation Program and Texas elevation and lidar resources.